« BMC-Assisted Debug | Main | The Minnowboard Chronicles Episode 2: Updating the UEFI Firmware »

Jan 08, 2017


Feed You can follow this conversation by subscribing to the comment feed for this post.


I just bought a MinnowBoard Turbo (MBT-2210) with a Debugger Lure and hooked it up to my Arium ECM-XDP3. I get error no. D6. There is an error detecting the JTAG chain. My Arium SourcePoint software is from around 2010, and the Intel Atom SoC on the MinnowBoard is circa 2013. I ran the command Jtagdevices() and did not see the Intel Atom processor listed.
Does this indicate I need to upgrade my SourcePoint software? Could there be some other problem?

Alan Sguigna

Hello Chen, yes you will need an update to the SourcePoint software, and you'll also need to obtain the Target Configuration (TC) file for the Bay Trail device. Your XDP3 hardware should work fine on the MNW Turbot.

You might also want to try jtagscan() and jtagconfigure() to ensure you have proper connectivity.

I'll drop you a note separately to get you started. Regards, Alan.

Verify your Comment

Previewing your Comment

This is only a preview. Your comment has not yet been posted.

Your comment could not be posted. Error type:
Your comment has been saved. Comments are moderated and will not appear until approved by the author. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.


Post a comment

Comments are moderated, and will not appear until the author has approved them.

Your Information

(Name and email address are required. Email address will not be displayed with the comment.)