« Common SATA Signal Integrity Issues | Main | SPI Flash JTAG Programming Using a Xilinx Spartan® FPGA »

Jun 08, 2014


Feed You can follow this conversation by subscribing to the comment feed for this post.


Thanks Alan!

It's been noted elsewhere that BER as used here should be written out as Bit Error Ratio (the unitless ratio of bits in error over bits in total) rather than as Bit Error Rate (the number of bits in error over time, expressed in bits per second, bps) ...

Verify your Comment

Previewing your Comment

This is only a preview. Your comment has not yet been posted.

Your comment could not be posted. Error type:
Your comment has been saved. Comments are moderated and will not appear until approved by the author. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.


Post a comment

Comments are moderated, and will not appear until the author has approved them.

Your Information

(Name and email address are required. Email address will not be displayed with the comment.)